The correct operating procedure for Garri fryer?

（1）Connect power to the equipment. When the power is turned on for the first time, check whether the equipment case is leaking. If a leakage is found, check the electrical wiring immediately, and then re-energize it after troubleshooting.
（2）Close the leakage protection switch, close the door of the electric control box, and set the working temperature through temperature controller.
（3）Turn on the fuel burner switch, pay attention to the position of the fuel tank higher than the height of the rotary joint, if necessary, exhaust at the fuel pump.
（4）Turn on heating switch and the burner will automatically start to work. If the burner does not ignite, turn off the heating switch and turn on the bleed switch at the solenoid valve until oil flows out. Then tighten the bleed switch and turn on the heating switch again. ignition. 2.When it reaches the working state, put into the materials and press the stirring button to start stirring. 3.When frying process is finished, turn off the stirring button to stop stirring, turn off the heating switch to stop heating; use the handle to tilt the pot to pour out the material. 4.To ensure cleanliness, it should be cleaned once every time it is used.
5.When the fryer is working, do not leave it unsupervised.